Tim Ovel and his crew from indiSYSTEM were doing a few shop tests recently and I thought I would share some footage to show the strength and ease of use of the ratchet handles on the indiSYSTEM Bulldog.

Here's a quick show down between Tim and one of his shop assemblers Tracy as they both demonstrate how easy it is to lock and tighten the ratchet handles on the indiSYSTEM Bulldog.

Each person hand tightens the center latch so that the carbon fiber rods don't roll and then lock the other two handles in place. Pretty straight forward stuff. It takes very little torque. No allen wrench necessary just a little arm strength.

Tim does a pretty good job but I think Tracy has got it down pat and may have the edge over Tim.

Tracy and Tim then put 53 pounds of steel on top of the handles of the Bulldog. It doesn't fall off!

You can check out the pictures at componentgeek.com

Loading more stuff…

Hmm…it looks like things are taking a while to load. Try again?

Loading videos…