VIdeo shot on a GoPro 1080 using a Noga articulating MagBase for ease of positioning.
This part is a replacement freehub body for an Easton Havoc rear mountain bike wheel. All work done manulally on lathe and mill. All measurements were taken from the original part and all other hardware including sealed bearings, pawls, springs and snaprings are from the original part. The original was aluminum but I was able to use a little titanium that was laying around the shop. The coolant kept fogging up the lens and I kept forgetting to clean it off. Some shots look fuzzy due to this. Light in the shop is low and the GoPro does not work the best in low light.
Loading more stuff…
Hmm…it looks like things are taking a while to load. Try again?