A little while ago, a viewer asked how he could turn a bowl without a chuck. He has a nice piece of wood and a new lathe but does not own a chuck. For many years now, I've consistently used a chuck when turning bowls.
As it turns out, I recently purchased a mini lathe myself and don't yet have a chuck to fit the new lathe. I figured now would be a perfect opportunity to try out the my new lathe and to take on the challenge of turning a bowl without using a 4-jaw chuck.
The last time, many years ago, I turned a bowl using only a faceplate, I left screw holes in the bowl's base. But now, I consider leaving screw holes totally unacceptable.
So, this was a challenge for me and the project had its issues. But in the end, I have a very nice small walnut bowl about 5 1/2 inches in diameter and 2 1/2 inches tall, finished with walnut oil. There are no screw holes in the base.
For the first mount, I screwed the faceplate to what would become the inside of the bowl and shaped the exterior. Then I glued a waste block to the bottom.
For the next mount, I screwed the faceplate to the waste block. Centering the faceplate on the waste block was a challenge. Then I refined the exterior and hollowed the interior.
For the final mount, I screwed the faceplate to a couple of layers of MDF shaped to fit the inside of the bowl. This was my jam chuck. With a little padding between the bowl and the jam chuck, the tail stock held the bowl on the lathe while I turned off the waste block.
I will now go back to using a 4-jaw chuck and will purchase one for my new lathe.
Enter your email at & I'll let you know when the next woodturning project video is ready.

Loading more stuff…

Hmm…it looks like things are taking a while to load. Try again?

Loading videos…