Martin S’s Videos
-
Measuring a brand new main shaft for run-out on one-way bearing surface
00:21119 Plays / 0 Likes / 0 Comments
Footage from my lathe with a dial gauge.
-
00:56157 Plays / 1 Likes / 0 Comments
Small solid fuel rocket with video camera onboard. Motor was an Estes C6-5. Parachute tangled on the fins. I had three goes at getting the audio sync right, but for whatever reason could not get…
-
FrSky range test for V8FR full range receiver
06:393,901 Plays / 2 Likes / 0 Comments
Note the road does go past trees at around 800m and 1800m. This receiver barely blinked at that, a very good result. At 2km even making the antennas cross polarized did not loose the signal.
-
FrSky V8R4 receiver range test.
06:274,074 Plays / 2 Likes / 0 Comments
At about 800 meters and about 1800 meters there is some clutter in the radio path (trees). But at 2km and before 800m there is good line of sight. Sorry about the other voice on the audio, CB radio…
-
Windrider Fox trying out glider tow.
02:32662 Plays / 0 Likes / 0 Comments
The tow plane is a very old J3 Cub that was rescued from a dump ! After being restored and electrified it's proven to be a powerful tug for smaller gliders. The EPP Windrider Fox is my sons slope…
-
01:23599 Plays / 2 Likes / 0 Comments
Showing the signal quality graph and alarm.
-
FrSky software monitor program
02:25985 Plays / 0 Likes / 0 Comments
This monitoring the two analogue channel from the remote receiver. The TX module serial output is plugged into the laptops comm port. This shows what the monitor does. I don't have any RS232 to display…
-
01:26261 Plays / 1 Likes / 0 Comments
One test run on the 'Ikea' gyro test stand - This one with analogue servo mode set on the HK-401B. Trying to reduce kick back from sudden stops in AVCS. Tried some pitch pumps to see if AVCS was coping.…
-
-
DIU rolls & mini half-pipes...
02:44224 Plays / 0 Likes / 0 Comments
Sadly the DV camera was set to lowest res. If you squint you can see the DIU going through some rolls and half pipes to show how my setup performs. It had the CoG at 18mm, and the 1/4 size slope soaring…
-
Mark Shorts custom built CBR600 GoKart
03:34182 Plays / 0 Likes / 0 Comments
Mega-powered bitumen kart.
+ More details -
11:46185 Plays / 0 Likes / 0 Comments
Slope soaring trip with the boys on Yorke Peninsula SA. December 2008.
