POWERSLIDE Vi - My Fit Liner – heat moulding with a hair dryer
Needed: your VI skates and a hair dryer, minimum 1500 W strong.
If you prefer heat moulding your Vi My Fit Liner with an oven instead of a hair dryer, have a look at our other heat moulding tutorial: vimeo.com/46876383
To improve and perfect the comfort and fit of your Vi skates, every skate comes with a heat mouldable Vi MY Fit liner.
The heat mouldable foam in the liner can be adjusted to your personal foot shape, forming the liner so it fits like a second skin.
To heat mould your Vi MY Fit liner, simply remove the liner from the Vi skate and take out the innersole.
Then put the hair dryer inside the liner (not too deep, so it still gets air and will not overheat).
Put the hairdryer on full temperature and full speed and it should take around 5 to 7 minutes to warm up one liner and then the moulding can begin.
Put the innersole back in and place your feet inside the warm Vi liner, put the heat moulding sock or any normal sock over the liner and put it back into the skate.
Lace them up as tight as possible.
Make sure to use all parts of the closure system: the buckle and the Atop clap snap wrap 360° closing system.
Now you must stand in your Vi skates in the skating position, and wait until the liner cools down.
The result will be a perfectly fitting liner and an extremely comfortable skating experience.
If needed this process may be repeated.