Luftbefeuchtung (Englisch)

  1. How does adiabatic cooling work?

    The indirect evaporative cooling is a process resulting in phase change evaporative cooling for cooling (eg cooling the air in an HVAC Plant ).

    indirect evaporative cooling this water evaporation takes place on the exhaust side One RLT - device whereby warm outside air is cooled via a subsequent recovery . The attainable cooling the outside air is thus dependent on the amount of evaporated water on the exhaust side and the design and the efficiency of the heat recovery employed . The exhaust can then be moistened to near saturation , without indeed a humidity increase in the supply air performance . In addition to air velocity , flows through which of the evaporative cooler , depends die evaporated water and thus die reaching cooling from the air condition from which the exhaust air to the evaporative cooler inlet .

    For more Information please visit:
    http://www.condair.de/fachwissen

    # vimeo.com/147702987 Uploaded 209 Plays 0 Comments
  2. What is the homogeneity index?

    The homogeneous distribution of moisture is crucial avoided That moisture stratification in subsequent components and
    short humidifying be enabled.
    The assessment of homogeneity in the steam injection does not cause problems, basic If you die once
    Relationships in mind Performs. The steam injection is better, the fine dosing of the steam and the
    large area it is distributed to the existing air cross section. Number and arrangement of the steam distribution owl type, number
    play area and distribution of steam nozzles die decisive role.
    According to VDI 6022 Part 1 Are steam humidifier to operate so, did condensate formation is avoided in the air lines.
    "That's why mess u. A. Die humidification dimensioned Sufficient and a homogeneous distribution of moisture over
    be the air cross section is ensured. "
    For quick and Descriptive Review homogeneous steam distribution at Dampfverteilregistern is the homogeneity
    Index very suitable.

    For more information please visit:
    http://www.condair.de

    # vimeo.com/147699351 Uploaded 9 Plays 0 Comments
  3. What is the humidification distance?

    The humidification is made up of the fog zone and the subsequent Expansion and mixing zone. As fog zone is the distance behind the humidification system - from the introduction until completely absorbed the amount of steam through the air conditioning. This is followed by the Expansion and mixing zone. In this stretch, the introduced moisture uniformly mixed with the air flow. The length of the required humidification depends in each case on the air in the direction of the following component. To avoid condensation phenomena inside the air ducts proper sizing of the humidification is extremely important. Also for the correct humidity control is their knowledge of fundamental importance, since the placement of the control sensor should take place only where balanced humidity values are available.

    For more information please visit:
    http://www.condair.de/fachwissen

    # vimeo.com/147701473 Uploaded 8 Plays 0 Comments

Luftbefeuchtung (Englisch)

Condair GmbH

Condair is the world’s leading manufacturer of commercial and industrial humidification and evaporative cooling products and systems, setting standards with regard to energy efficiency and hygienic solutions. We export to over 50 countries throughout…


+ More

Condair is the world’s leading manufacturer of commercial and industrial humidification and evaporative cooling products and systems, setting standards with regard to energy efficiency and hygienic solutions. We export to over 50 countries throughout the world. Our important own product brands are: Condair, Nortec, Defensor, Draabe and ML System.

Condair is represented in the UK by Condair plc, which offers humidifier system advice, design, manufacture, supply, installation, commissioning, maintenance and spares from its base in Littlehampton, West Sussex. The company supports Condair sales activities in the UK, Ireland, Oceania, South East Asia, and Central and Southern Africa.

From its production facility in West Sussex, Condair plc manufactures the JetSpray compressed air and water spray humidifier, the Condair ME in-duct evaporative humidifier and cooler, and the PureFlo Reverse Osmosis water filter, all of which are distributed throughout the global Condair Group sales network.

Condair plc is the new name for JS Humidifiers, following the company becoming a member of the Condair Group in 2011 and rebranding to Condair plc in October 2014.

In this Channel we explain everything around humidification and evaporative cooling.

Please also visit our homepage
http://www.condair.de

Browse This Channel

Shout Box

Heads up: the shoutbox will be retiring soon. It’s tired of working, and can’t wait to relax. You can still send a message to the channel owner, though!

Channels are a simple, beautiful way to showcase and watch videos. Browse more Channels.